Subaru EJ Top Feed TGV Delete Kit

Subaru EJ TGV Delete Kit

This TGV Delete Kit is 3D printed with High-Quality PA6 Carbon Fiber Nylon filament which is known for its extreme strength and temperature resistance. This means it will have no problem performing its job even in the hottest engine bays. I designed this TGV Delete Kit to use set screws to plug the factory TGV shaft and use 3D printed covers to take the place of the TGV motors to give it a clean finished look. 

Installation Instructions

1. Remove Stock TGV's
2. Remove the TGV motor and position sensor if applicable
3. Grind the back of the bolt off of the bolts holding the butterfly valve on the shaft (the ends are peened which needs to be ground down to unscrew the bolt without stripping it). Remove the bolts.
4. Remove TGV Shaft.
5. Remove bearings and seals if they do not come out with the shaft.
6. Tap the shaft hole with 3/8"-16 Tap (Not Included).
7. Clean threads and set screws (Included).
8. Apply JB Weld (Not Included) to set screw and threads, and screw into the taped holes until the top of the set screw is past where the covers sit, and let JB Weld cure.
9. For best performance, it is recommended that the divider plates are removed and blended smooth with surrounding surfaces, as well as the end of the set screws ground flush.
10. Install 3D-printed TGV motor covers with the included hardware.
11. Reinstall TGV.
12. CEL will be present after removing the TGV motors and must be cleared by a tuner.

Features

• Designed and Made in the USA with High-Quality PA6 Carbon Fiber Nylon
• Stainless Steel Hardware
• Chemical and High Temperature Resistant
• Quality Appearance and Construction
• Affordable Price

Fitment

• 2008 - 2014 Subaru WRX
• 2007 - 2021 Subaru STI 
• 2007 - 2012 Subaru Legacy GT
• 2007 - 2009 Subaru Outback XT
• 2008 - 2013 Subaru Forester XT

Deleting TGVs will make your car non-emission compliant. For this reason, this kit is for Off-Road Use Only.

Kit Includes

4x Quality 3D Printed TGV Motor Covers

2x 3/8"-16 5/8" Set Screws

4x M6-1.00 12mm Hex Flange Bolts

4x M4-0.70 10mm Button Head Hex Bolt